Conveyor belt hot vulcanizate and vulcanized film characteristics and uses

    This product is a high performance adhesive consisting of a flame retardant vulcanizate and vulcanized film. It has the characteristics of high temperature resistance, water resistance, oil resistance, aging resistance, glue can not be burned when exposed to fire, and high bonding strength.

    This product is widely used in various rubber conveyor belts, steel core conveyor belts, whole core conveyor belts, nylon, canvas, polyester conveyor belt joints vulcanized and glued, especially suitable for the above-mentioned conveyor belt joint vulcanization in high temperature environment.

How to avoid the belt not being glued on both sides after the vulcanization? The inner core glue is fully melted?

    Now the vulcanized joint sometimes has a loose side and a loose side, and there is a serious deviation. The seal on both sides of the belt and the non-working surface is easy to open, and the inside is easy to become empty. We are now using stepped laps. Polishing is not bad. Nylon cloth is also cleaned with gasoline. The 0.75 thick thin film used in the core rubber. The glue we used was made from gasoline and the thin film on it. Now the center line of the belt head pair is also positive. After the belt is connected, the belt will be tight and loose on one side, which will be biased and not easy to adjust. The seal on the non-working surface will also be reinforced, but it is easy to open the glue. After the belts were touched on both sides, there were obvious marks, and the film on the side of the belt was extruded and foamed. Is this undervoltage? Also, we warmed up to 150, sometimes directly power off and cool down, and do not keep warm.